Hi Experts
We are using BI 7.0. I am working on LSO functional area in HR implementing BW.
I am trying to load a generic DSO using 0HR_0LSO_3 DataSource. However, the tranffic lights remain 'Amber' and the data is not loading into the PSA. The status is coming up as below:
-
No data available
Diagnosis
The data request was a full update.
In this case, the corresponding table in the source system does not
contain any data.
System Response
Info IDoc received with status 8.
Procedure
Check the data basis in the source system.
-
When I clicked on Step-by-Step Analysis, it is showing up 'Red' traffic lights for:
'Does selectable data exist in the source system?' and
'Data selection successfully started ?'
Upon clicking on these 'Red' lights, it is showing up the following message:
-
Diagnosis
The data request was a full update.
o In this case, the corresponding table in the source system does not
contain any data.
o System Response
Info IDoc received with status 8.
Procedure
Check the data basis in the source system.
-
Actions I've taken:
1. There is data in 0HR_0LSO_3 when checked in RSA3.
2. Replicated the DataSource.
3. Connection between BW and ECC is OK.
4. Checked and made sure no failed requests in the PSA.
5. Checked the length of InfoObjects and Fields and they are all good.
6. Been through many threads talking about this problem but no relevant solution found to this problem.
I would appreciate if anyone has been in a similar situation could please throw some light on this problem.
Thanks for your time in advance.
Regards,
Chandu